GE GFK-2489 Network Router User Manual


 
GFK-2489 Chapter 4 Remote Radio Management
4-9
4
MODE=<mode>—Switches the console port among various interface modes.
MODE cannot be set to DATA unless the device has been authorized for serial
payload.
DATA: places COM2 in transparent data mode
BSP: places COM2 in Basic Serial Protocol mode
INT_LOOP: places COM2 in internal loopback mode
EXT_LOOP: places COM2 in external loopback mode
DISABLED: COM2 is not operational
RXDELAYCHARS= Sets the inter-packet receive gap size in character times
(1-65535).
TXDELAY= Sets the inter-packet delay in milliseconds (1-65535). The
minimum TXDELAY setting should be set to two times the Dwelltime setting.
When TXDELAY is set to less than twice the Dwelltime setting, the measured
inter-packet delay can increase up to one dwelltime (7,14, or 28 ms) period.
CONFIG Saves or displays the current configuration. The output is in a format that may
be copied back into the command line in order to set the configuration.
Optional arguments:
SHOW —Displays the current configuration. This is a read-only
response.
SAVE=FACT —Programs the current configuration into the Factory
Default configuration table. The factory default is used to
restore the configuration when the system detects a data
corruption.
DEVICE Displays the device configuration, and allows setting of the OWNER, NAME, and
LOCATION.
Optional arguments:
CMD —Displays all settable optional arguments and their current
values. You can copy this list to a text file as a record of your
configuration.
COMPANY —(read only) Displays the company name.
MODEL —(read only) Displays the radio model number.
PRODUCT —(read only) Displays the product name.
REV —(read only) Displays the software revision ID.