GE GFK-2489 Network Router User Manual


 
GFK-2489 Chapter 3 AP Management 3-37
3
Remote Management Submenu
The Remote Management Menu allows selection of a particular Remote to manage, based on
the radio Unit ID number (generally the last four digits of its serial number).
Remote Management Menu
A) Remote to Manage 0
B) Manage Selected Remote
C) Broadcase Remote Reprogramming
Select a letter to configure an item, <ESC> for the prev menu
Remote to Manage—Radio address of the Remote to be managed (typically a
four-digit code).
Manage Selected Remote—Displays the screen shown next. It contains several
parameters that are used to set the characteristics of Remote radios in the
network.
Broadcast Remote Programming—Selecting this item brings up a submenu
where you may initiate the broadcast of new firmware images and Remote restart
commands.
Before programming a Remote radio over the air, be sure to set ETHERNET
BRIDGING (see “Bridge Configuration Menu”) from ALL (default) to either
DISABLED or NO BROADAST/MULTICAST. Otherwise, you may experience sync
errors, or programming may not complete. Excessive broadcast/multicast traffic
from a connected LAN can also cause problems.