Filter
Top Products
6 CIMPLICITY® Display Station Touch Display: IC752CTD400/450
–
March 1998 GFK-1425B
Mounting Procedure
1
.
Cut out the panel to the dimensions shown. The cut-out dimensions of 367 x 255mm
(14.45 x 10.04 inches) allow a 1.5mm (0.06 inch) clearance on each edge of the Touch Display
unit.
Figure 2. Panel Cutout Dimensions
2
.
Position the Touch Display unit in the cut-out and fit the ten spring-loaded retaining clips into
the slots.
All ten clips must be installed to achieve a good seal
.
Figure 3. Mounting the Touch Display Unit
3
.
Screw in the tightening screw on each clip so that the nut compresses the spring. To ensure a
good seal between the Touch Display unit and the panel, tighten the clips evenly (tighten each
of the ten clips in turn, a little at a time).
4
.
Stop tightening the clips when the springs are fully compressed — at this point the Touch
Display unit is locked in place.