Filter
Top Products
GFK-1425B Touch Display Products: IC752CTD400/450 27
Troubleshooting
Powerup
Symptom Possible Causes Solution
For Windows NT systems only:
The following error message
appears:
The system could not
log you on. Make sure
your User name and
Domain are correct ...
You did not type
ge
for the
password during initial setup.
Set the logon password to
ge
. For
instructions, see “Auto Logon
Error Message” on page 33.
Display Station does not power
up.
Power not on (PWR indicator not
lighted or display completely
dark).
Make sure that Display Station is
plugged in. Make sure that power
source is functioning properly.
Display is blank (PWR indicator is
lighted).
See “Display” on page 28. See “Display” on page 28.
Non-System disk or disk
error
message displayed.
Disk in floppy disk drive. Remove floppy disk and then
reboot or power cycle.
Safe Recovery Error
message displayed.
Occurs on initial power up if the
unit is accidentally turned off
without first shutting down the
Windows 95 software.
The Display Station will power up
normally.
Memory count during powerup
self-test is incorrect.
Optional SIMM is installed
incorrectly or is incompatible with
the Display Station CPU.
Make sure that the appropriate
memory is installed correctly.
CMOS checksum error —
Defaults loaded
CMOS battery failed
message displayed.
CMOS battery failure.
Note:
This battery has a lifetime
of up to 10 years under normal
operating conditions. The battery
is not field replaceable. For more
information, see “CMOS
Checksum Error” on page 33.
A screen appears just after
powerup, or just after reset, which
has the title “CMOS Setup
Utility.”
The
D
EL
key has been
accidentally pressed.
Cycle power again. The Display
Station will power up normally.
The Display Station reset even
though the power was not
interrupted.
The
C
TRL
-A
LT
-D
EL
keys were
pressed twice at the same time.
This should never be done, unless
you are attempting to reset the
Display Station.
A:> appears instead of software. A system floppy disk is inserted. Remove disk and cycle power.