HandyTone-486 User Manual Grandstream Networks, Inc.
11
• Call Flashing. When in conversation, user can also flash to the third party by
pressing flash(or Flash Hook for old style phones) button to get a dial tone and
then dial the third party number.
5.2.4
Blind Transfer
Assume that call party A and B are in conversation. A wants to Blind Transfer B to C:
1. A presses FLASH (on the analog phone, or Hook Flash for old model phones) to
get a dial tone.
2. Then A dials *87 then dials C’s number, and then #(or wait for 4 seconds)
3. A can hang up.
NOTES:
• Call Feature has to be set to YES in web configuration page.
A can hold on to the phone and await one of the three following behaviors:
• A quick confirmation tone (temporarily using the call waiting indication tone)
follows by a dial tone. This indicates the transfer has been successful (transferee
has received a 200 OK from transfer target). At this point, you can either hang up
or make another call.
• A quick busy tone followed by a restored call (On supported platforms only).
This means the transferee has received a 4xx response for the INVITE and we
will try to recover the call. The busy tone is just to indicate to the transferor that
the transfer has failed.
• Busy tone keeps playing. This means we have failed to receive the second
NOTIFY from the transferee and decide to time out. Note: this does not indicate
the transfer has been successful, nor does it indicate the transfer has failed. When
transferee is a client that does not support the second NOTIFY, this will be the
case. In bad network scenarios, this could also happen, although the transfer may
have been completed successfully.
5.2.5
Attended Transfer
Assume that call party A and B are in conversation. A wants to Attend Transfer B to C:
