Filter
Top Products
Busy
Error
Load Media
Error
8Ć6 Troubleshooting
C3187Ć90000
Error
and Busy flashing
Possible Causes Corrective Action
The serialĆinterface settings are different on the
plotter and on the software.
1. Print a setup sheet and check the plotter's
current settings for Baud Rate and Parity.
2. Compare these with the current settings of
the same two items for your application
software. They must be the same.
3. If necessary, change the plotter's settings.
The serialĆinterface cable is not correctly
connected.
Connect the cable correctly.
The computer is ignoring the plotter's handshake
signals.
If the computer is using hardware handshake,
ensure that the serialĆinterface cable has a
handshake wire.
Error and Load Media flashing
Possible Causes Corrective Action
The media does not advance around the roller
when loaded.
Remove the media and reload it.
You loaded the media too far from the right
side.
Remove the media and reload it, aligning the
right edge between the two dashed lines on the
loading area.
The leading edge of the media is not parallel to
the roller.
Reload the media, aligning it correctly.
The media is too small for the plotter. Use an AĆsize or A4Ćsize sheet or larger. Load
in portrait orientation for setup and
alignĆcartridge routines.
See also D later in this chapter, w Problems in Loading Media.