Filter
Top Products
Cancel
Replot
8Ć29 Removal and ReplacementC3187Ć90000
The block of text on the service configuration plot that shows the contents of the
EEROM, appears in the form shown in Table 8Ć3. This table is a text block from a sample
plot. The contents of the EEROM that you are testing will differ from this sample.
Table 8-3. Sample EEROM Contents Text Block
EEROM contents:
0: 55 aa 5a 0 20 0 0 0 – 2b 0 0 0 3a 0 0 0
10:0044310000–00000000
20: 3 20 3 a3 a3 a3 a3 a3 – a3 a3 a3 a3 a3 a3 a3 a3
30:a3a302100081–8835000e0fe1d
40:f2022527f2f29–9e0e1f00500
50:000008d01–deed573ed38edb3d
60:eedb3a16000–200cac4390
70:00000000–0000000c9
80: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
90: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
a0: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
b0: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
c0: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
d0: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
e0: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
f0: ff ff ff ff ff ff ff ff – ff ff ff ff ff ff ff ff
Clearing the EEROM
Careful: If you clear the EEROM, you will then need to perform all of the plotter
calibrations. (Details D chapter 7.)
To clear the EEROM, perform the following procedure:
1 Switch the plotter off.
2 While holding both the Cancel and Replot keys down,
switch the plotter on.
3 Once the Busy LED lights up, release the Cancel and Replot keys.