Filter
Top Products
8Ć9 TroubleshootingC3187Ć90000
Error
and Load Media LEDs lit and steady:
MediaĆpath/servo errors.
LEDs lit
and
steady
Error Number and
Description
Corrective Options
82. Shutdown of media axis
(XĆaxis)
See D later in this chapter, w ServoĆControl
System Failures.
22. Shutdown of carriage axis
(YĆaxis)
See D later in this chapter, w ServoĆControl
System Failures.
86. CarriageĆaxis failure Check encoder strip, carriage assembly,
trailing cable, main PCA.
50. CartridgeĆcap failure See D later in this chapter, w Frequent
Cartridge Failure. / Check the service
station, encoder strip and media motor.
114. Error detected in mediaĆaxis
servo feedback loop.
Check media motor, mediaĆmotor encoder
cable, main PCA.
54. Error detected in
carriageĆaxis servo feedback loop.
Check encoder strip, carriage assembly,
trailing cable, main PCA.
118. Bail sensor indicates the bail
is up when it should be down or
vice versa, or the bail drops
suddenly (missing the notch on
the auto cam).
See D later in this chapter, w BailĆLiftĆ
Mechanism Failure. / Use the bailĆsensor
test to help troubleshoot. / Check for
mechanical problems. / Perform the bail
calibration.
146. AccuracyĆcalibration error Did you load the media in the correct
orientation? / Ensure that the marks are
visible on the plot. If not, check cartridges. /
Ensure that the sheet is cut correctly. /
Perform a cartridge alignment: if alignment
is correct, the problem may be in the main
PCA, media motor or media motor gear; if
alignment is incorrect, the problem may be
in the carriage.
210. MediaĆsensorĆcalibration
error. One of the flags on the
media sensor may be positioned
too far forward or too far back.
Replace the media sensor. If the error
persists, there may be a problem with the
LED on the cartridge carriage: Perform a
cartridge alignment / Replace LED.