Filter
Top Products
1 Remove the electronicsĆenclosure
cover ' page 6Ć5.
2 Remove the window ' page 6Ć15.
3 Remove the center cover ' page 6Ć16.
4 Remove the left endcover ' page 6Ć18.
5 Open the flexible, DANGER HIGH
VOLTAGE," insulation cover.
Carefully flex the cover to open t Do not
detach the cover from the plotter
6 Disconnect the stepperĆmotor cable
connector from the main PCA and the
holding clip.
Stepper-motor
connector
7 Remove the bottom shoulder screw on
the cartridgeĆadjust linkage, and lower
the lever arm below the stepper motor.
0D2DmbtinJ: Rest the bottom arm of the
lnkage on top of the stepperĆmotor shaft
Torx-15
6Ć21 Removal and ReplacementC3187Ć90000
Removing the Stepper Motor