Filter
Top Products
Chapter 3 Connecting Hosts 43
Connecting Remote Management Hosts
The management host directly manages systems out-of-band over an Ethernet
network. This section describes how to connect the Ethernet cables to the
management host.
1. Connect an Ethernet cable to the Ethernet management port on each controller.
Note – Do not confuse Ethernet management ports with Ethernet host ports, also
located on the rear panel of the controller enclosure. For a description of controller
enclosure ports, see “Hardware Components and LEDs” on page 13.
2. Connect the other end of each Ethernet cable to a network that your management
host can access (preferably on the same subnet).
Next Steps
After you have connected the management host and data hosts, you are ready to
perform first-time configuration on the storage system and data hosts as described in
Chapter 4.