Filter
Top Products
to print indefinitely. The default setting is 0 seconds. You can use the spin box to change this value
to a maximum of 32,767 seconds.
Wait Timeout
This control specifies how long the product waits to get more postscript information from the
computer. After the specified time passes, the product stops trying to print the document and prints
an error message. If you are trying to print a very complicated document, you might want to increase
this value. If you specify 0 seconds, the product waits indefinitely. The default setting is 300
seconds. You can use the spin box to change this value to a maximum of 32,767 seconds.
Minimum Font Size to Download as Outline
This control specifies the minimum font size (in pixels) for which the driver downloads TrueType fonts
as outline (Type 1) fonts. A font smaller than the minimum setting is downloaded as a bitmap (Type
3) font. Use this option to fine-tune the Automatic setting for the TrueType Font Download option
on the Advanced tab in Document Defaults. The default setting is 100 pixels. You can use the spin
box to change this value to a maximum of 32,767 pixels.
Maximum Font Size to Download as Outline
This control specifies the maximum font size (in pixels) for which the driver will download TrueType
fonts as bitmap (Type 3) fonts. A font larger than the maximum setting will be downloaded as an
outline (Type 1) font. Use this option to fine-tune the Automatic setting or override the Send
TrueType as Bitmap setting for the TrueType Font Download option on the Advanced tab in
Document Defaults. The default setting is 600 pixels. You can use the spin box to change this value
to a maximum of 32,767 pixels.
Installable Options
This section provides information to configure the printing options that you can install for the
HP LaserJet 2410, 2420, and 2430 printers. The following controls are available:
■ Automatic Configuration
■ Tray 3
■ Duplex Unit (for 2-Sided Printing)
■ Allow Manual Duplexing
■ Printer Memory
■ Job Storage
■ Mopier Mode
■ Postscript Passthrough (PS Emulation Unidriver only)
Automatic Configuration
Use the Device Settings tab to tell the driver about the hardware configuration of the product. If
bidirectional communication is enabled in a supported environment, set up this tab by selecting the
Update Now option under Automatic Configuration. The default setting is Off. After an automatic
configuration, the setting returns to Off after the changes are made.
HP PCL 6, HP PCL 5e, and PS emulation unidriver features 217
HP unidrivers