36 Getting Started
Product information
Additional information on the potential energy and financial savings of the power
management feature can be found on the EPA ENERGY STAR Power
Management Web site at http://www.energystar.gov/powermanagement.
Additional information on the ENERGY STAR program and its environmental
benefits are available on the EPA ENERGY STAR Web site at
http://www.energystar.gov.
Laser compliance
This product may be provided with a device containing a laser that is classified as a
Class 1 Laser Product in accordance with US FDA regulations and the IEC
60825-1. The product does not emit hazardous laser radiation.
Each laser product complies with 21 CFR 1040.10 and 1040.11, except for
deviations pursuant to Laser Notice No. 50, dated May 27, 2001; and with IEC
60825-1:1993/A2:2001.
Å
WARNING: Use of controls or adjustments, or performance of procedures other than
those specified in the laser product installation guide, may result in hazardous
radiation exposure. To reduce the risk of exposure to hazardous radiation:
■ Do not try to open the module enclosure. There are no user-serviceable
components inside.
■ Do not operate controls, make adjustments, or perform procedures to the laser
device other than those specified in the laser product installation guide.
■ Allow only authorized service providers to repair the unit.
Modem notices
Å
WARNING: To reduce the risk of fire, electric shock, and injury to persons when
using this device, always follow basic safety precautions, including the following:
■ Do not use this product near water—for example, near a bathtub, wash bowl,
kitchen sink or laundry tub, in a wet basement, or near a swimming pool.
■ Avoid using this product during an electrical storm. There is a remote risk of
electric shock from lightning.
■ Do not use this product to report a gas leak while in the vicinity of the leak.
■ Always disconnect the modem cable before opening the equipment enclosure or
touching an uninsulated modem cable, jack, or internal component.
■ If this product was not provided with a telephone line cord, use only 0.126 mm²
(No. 26 AWG) or larger telecommunication line cord.
■ Do not plug a modem or telephone cable into the RJ-45 (network) jack.
SAVE THESE INSTRUCTIONS
462939-001.book Page 36 Thursday, March 20, 2008 9:03 AM