Filter
Top Products
46 Getting Started
Product information
3. Where automatic calls are made to different numbers, the equipment shall be
set to go on-hook for a period of not less than 5 seconds between the end of
one attempt and the beginning of the next attempt.
4. The equipment shall be set to ensure that calls are answered between 3 and
30 seconds of receipt of ringing (So set between 2 and 10).
Voice support
All persons using this device for recording telephone conversations shall comply
with New Zealand law. This requires that at least one party to the conversation is
aware that it is being recorded. In addition, the Principles enumerated in the
Privacy Act 1993 shall be complied with in respect to the nature of the personal
information collected, the purpose for its collection, how it is to be used, and what
is disclosed to any other party.
This equipment shall not be set to make automatic calls to the Telecom ‘111’
Emergency Service.
Power cord notices
If you were not provided with a power cord for the computer or for an external
power accessory intended for use with the computer, you should purchase a power
cord that is approved for use in your country or region.
The power cord must be rated for the product and for the voltage and current
marked on the product's electrical ratings label. The voltage and current rating
of the cord should be greater than the voltage and current rating marked on
the product. In addition, the diameter of the wire must be a minimum of
0.75 mm²/18AWG, and the length of the cord must be between 1.5 m (5 ft) and
2 m (6½ ft). If you have questions about the type of power cord to use, contact your
authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by
items placed upon it or against it. Particular attention should be paid to the plug,
electrical outlet, and the point where the cord exits from the product.
Japanese power cord notice
462939-001.book Page 46 Thursday, March 20, 2008 9:03 AM