Filter
Top Products
1-29
Installing the Tape Library
Moving or Shipping the Library
Installation
6. If the library is rack mounted:
a. Extend the anti-tip rail on the rack.
WARNING Failure to extend the anti-tip rail could result in personal injury and/or damage
to the library if the rack tips over.
b. Slide the library out of the rack so that it is in the fully extended position.
c. Reattach the handles to the side of library using two screws. Make sure the
handle flanges are on top of the slides. (The handles and hardware for
reattaching them should have been saved with the original shipping
materials. If they are missing, call your service representative to order
replacement handles.)
d. Remove the three 8-32 screws on each side of the library that secure the
library to the rack slides.
e. IMPORTANT — two people needed: With a person on each side of the
library, lift the library onto a cart.
7. Transport the library:
• To move the library a short distance, roll the cart to the new location.
• To ship the library, repackage the library in the same materials and ship it in
the same manner in which it was received.
CAUTION The library can be seriously damaged if it is not shipped using appropriate shipping
materials. A service representative can provide assistance or advice on how to best
repackage and ship the library.
8. Re-install the library. Refer to installation steps in this chapter.