Filter
Top Products
Remove the display cables:
1. Position the computer right-side up with the front toward you.
2. Open the computer as far as possible.
3. Disconnect the display panel/webcam cable assembly (1) from the system board.
4. Remove the microphone module cable from the routing path (2), and then disconnect the cable
(3) from the system board.
5. Remove the WLAN wireless antenna cables (4) from the tape, clips and routing channels built into
the top cover.
6. On models with a WWAN module, remove the WWAN wireless antenna cables (5) from the tape,
clips and routing channels built into the top cover.
Remove the display assembly:
CAUTION: Support the display assembly when removing the following screws. Failure to support the
display assembly can result in damage to the display assembly and other computer components.
1. Remove the six Phillips PM2.5×6.0 screws (1) that secure the display assembly to the computer.
2. Lift the display assembly (2) straight up and remove it.
Component replacement procedures 79