Filter
Top Products
Upgrade and replacement procedures 63
7.
Install the capacitor pack onto the bracket, leaving sufficient room to connect the capacitor pack cable.
CAUTION: When connecting or disconnecting the capacitor pack cable, the connectors on the
cache module and cable are susceptible to damage. Avoid excessive force and use caution to
avoid damage to these connectors.
8. Connect the capacitor pack cable to the cache module.
9. Install the controller in the server blade.
After installing a capacitor pack, you might see a POST message during reboot indicating that the array
accelerator (cache module) is disabled temporarily. This behavior is normal because the new capacitor pack
is likely to have a low charge. You do not need to take any action, because the recharge process begins
automatically after the capacitor pack is installed and the server is powered. The controller operates properly
while the capacitor pack recharges, although the performance advantage of the array accelerator is absent.
When the capacitor pack has been charged to a satisfactory level, the controller enables the array
accelerator automatically.
Replacing a P712m cache module