Filter
Top Products
ENWW Chapter 4: Problem Solving 107
PCL or PS Font List
Use the font lists to see which fonts are currently installed in the
printer. (The font lists also show which fonts are resident on an
optional hard disk or flash DIMM.)
To print a PCL or PS font list:
1 Press [Menu] until INFORMATION MENU appears.
2 Press [Item] until PRINT PCL FONT LIST or PRINT PS FONT LIST
appears.
3 Press [Select] to print the font list.
The PS font list shows the PS fonts installed, and gives a sample
of those fonts. The following describes the information that can be
found on the PCL font list:
• Font gives the font names and samples.
• Pitch/Point indicates the pitch or point size of the font.
• Escape Sequence (a PCL programming command) is used to
select the designated font. (See the legend at the bottom of the
font list page.)
Note For step-by-step instructions on using printer commands to select
a font with DOS applications, see page D-7.
• Font # is the number used to select fonts from the printer’s control
panel (not the software application). Do not confuse the font #
with the font ID, described below. The number indicates the DIMM
slot where the font is stored.
• SOFT: Downloaded fonts, which stay resident in the printer until
other fonts are downloaded to replace them, or until the printer
is turned off.
• INTERNAL: Fonts that permanently reside in the printer.
• Font ID is the number you assign to soft fonts when you download
them through software.