Filter
Top Products
NOTE: For a fault-tolerant dedicated service LAN, two G4SAs are required, with each G4SA
connected to a separate maintenance switch. These G4SA can reside in modules 2 and 3 of the
same IOAM enclosure or in module 2 of one IOAM enclosure and module 3 of a second IOAM
enclosure. When the G4SA provides connection to the dedicated service LAN, use the slower
10/100 Mbps PIF A rather than one of the high-speed 1000 Mbps Ethernet ports of PIF C or D.
Dedicated Service LAN Links Using IP CLIMs
You can implement up-system service LAN connectivity using IP CLIMs, if the system has at
least two IP CLIMs. The values in this table show the identification for the CLIMs in a NonStop
BladeSystem and connected to the maintenance switch. In this table, a CLIM named C1002581
is connected to the first fiber and eighth port of the ServerNet switch in Group 100, module 2,
interconnect bay 5 of a c7000 enclosure:
IP ConfigurationTCP/IP StackCLIM Location
IP: 192.168.36.10
Subnet:
%hFFFF0000
Hostname: osmlanx
$ZTCP0100.2.5.8.1
IP: 192.168.36.11
Subnet:
%hFFFF0000
Hostname: osmlany
$ZTCP1100.2.5.8.2
NOTE: For a fault-tolerant dedicated service LAN, two IP CLIMs are required, with each IP
CLIM connected to a separate maintenance switch.
Initial Configuration for a Dedicated Service LAN
New systems are shipped with an initial set of IP addresses configured. For a listing of these
initial IP addresses, see “IP Addresses” (page 84).
Factory-default IP addresses for the G4SAs are in the LAN Configuration and Management Manual.
IP addresses for SWAN concentrators are in the WAN Subsystem Configuration and Management
Manual.
HP recommends that you change these preconfigured IP addresses to addresses appropriate for
your LAN environment. You must change the preconfigured IP addresses on:
• A backup system console if you want to connect it to a dedicated service LAN that already
includes a primary system console or other system console
• Any system console if you want to connect it to a dedicated service LAN that already includes
a primary system console
Keep track of all the IP addresses in your system so that no IP address is assigned twice.
System Consoles
New system consoles are preconfigured with the required HP and third-party software. When
upgrading to the latest RVU, you can install software upgrades from the HP NonStop System
Console Installer DVD image.
Some system console hardware, including the PC system unit, monitor, and keyboard, can be
mounted in the cabinet. Other PCs are installed outside the cabinet and require separate provisions
or furniture to hold the PC hardware.
System Consoles 89