Filter
Top Products
Hardware options installation 48
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To install a processor:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 22).
o For rack models, if installed, remove the security bezel (on page 24).
2. Power down the server (on page 22).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel (on page 25).
5. For rack models, do the following:
a. Extend the server from the rack (on page 27).
b. Remove the access panel (on page 25).
6. Remove the PCI air baffle (on page 28), if installed.
7. Remove the system air baffle (on page 30).
8. Open each of the processor locking levers in the order indicated, and then open the processor retaining
bracket.