Filter
Top Products
68
Interpreting error codes
When errors occur while you are sending or receiving faxes, an error message is
included on the Last Transaction and Last 32 Transaction reports. The RESULT
column of the report contains the word ERROR and an error code is printed to
the right of the message. These codes report the following error conditions. If
you resend a fax that reported an error, watch the front panel display for
messages. For help on messages, see "Understanding display messages".
Code numbers Condition Remedy
030 through 031 Document misfeed The document did not feed correctly. Try
resending.
421 through 425 Sending error while dialing. Check for a dial tone, then try resending.
441, 442,
444 through 483 and
531 through 567
Sending error. This may be the result of a bad connec`
tion. Try resending.
501 through 506,
508 through 516 and
571 through 582
Receiving error. This may be the result of a bad connec`
tion. If you received this fax, be sure to
check it for completeness. You may want
to ask the sender to resend the fax.
591, 594 and 595 Stop button was pressed while
receiving a fax.
Ask the sender to resend the fax.
592, 593 Stop button was pressed while
sending a fax.
You may want to resend the fax.
507 Reception memory full, reception
stopped.
A fax exceeded the memory or cannot
print. If you received this fax, be sure to
check it for completeness. You may want
to ask the sender to resend the fax.