Filter
Top Products
81
Electromagnetic or Radio Frequency Interference - FCC Requirements
This equipment generates and uses radio frequency energy and may causeinterference to radio and television reception. Your facsimile
complies with the specifications of Part 15 of theFederal Communications Commission rules for a Class B digital device. These specifications
provide reasonable protection against such interference in residential installation. However, there is no guarantee that interference will not occur
in a particular installation. If thefacsimile does cause interference to radio or television reception, which can be determined by turning the
facsimile off and on, you cantry to eliminate the interference problem by doing oneor more ofthe following.
:
Reorient the receiving antenna.
:
Reorient the position of the facsimile with respect to the receiver.
:
Move the facsimile away from the receiver.
:
Plug the facsimile into a different outlet so that the facsimile and the receiver are on different branch circuits.
If necessary, consult an authorized HP service agency or an experienced radio/television technician for additional suggestions. You may find the
following booklet, prepared by the Federal Communications Commission, to be helpful: "How to Identify and Resolve Radio/TV Interference
Problems." This booklet is available from the U.S. Government Printing Office, Washington DC 20402, Stock No. 004-000-00345-4.
CAUTION:
Changes or modifications not expressly approved by Hewlett-Packard for compliance could void the user's authority to use the
equipment.
Notice to Users of the Canadian Telephone Network - IC Requirements
Notice:
The Industry Canada label identifies certified equipment. The certification means that the equipment meets certain telecommunications
network protective operations and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications
company. The equipment must also be installed using an acceptable method of connection. In some cases, the company's inside wiring
associated with a single line individual service may be extended by means of acertified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or
alterations made by the user to this equipment or equipment malfunctions, may give the telecommunications company cause to request the user
to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic
water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
CAUTION:
Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.
The connecting arrangement code for this equipment is CA11A.
The Load Number for the HP FAX-700 is 5.0 .
The Load Number(LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop or circuit
which is used by the device to prevent overloading. The termination on a loop may consist of any combination of devices subject only to the
requirement that the total of the load numbers ofall devices does not exceed100.