Filter
Top Products
6 Output devices
66
Multifunction finisher
Multifunction finisher
Paper handling features
l stacks up to 1000 sheets of A4- and Letter-size paper or up to 500 sheets of A3- and Ledger-size paper
l stacks up to 50 booklets of 5 sheets of A3- and Ledger-size paper
l offsets jobs
l staples up to 50 sheets of paper per document of A4- and Letter-size paper
l staples up to 25 sheets of paper per document A3- and Ledger-size paper
l folds single pages
l saddle-stitches and folds booklets up to 10 sheets of paper (40 pages).
Using the stapler
The finisher can staple documents consisting of a minimum of two pages, and a maximum of 50 pages of 75
g/m
2
(20 lb) paper or equivalent 5.5 mm (.22 inches). The pages must be 64 to 199 g/m
2
(17 to 53 lb) of all
sizes supported by the product.
Consider these additional points:
l Bin 2 can hold up to 1000 sheets stacked (not stapled).
l Heavier media may have a stapling limit of fewer than 50 pages.
If the job you want stapled consists of only one sheet, or if it consists of more than 50 sheets, the finisher
delivers the job to the bin without staples.
Selecting the stapler
You can usually select the stapler through your program or driver, although some options might be available
only through the driver. See “STAPLING DOCUMENTS” on page 51 or “SADDLE STITCHING” on page 50.
Where and how you make selections depends on your program or driver.
If you cannot select the stapler from the program or driver, select the stapler from the product control panel.
ENWW