Filter
Top Products
2-40 edge switch 2/32 installation guide
Installing and Configuring the Edge Switch 2/32
2. To enable transmission of trap messages to configured SNMP management
workstations, click Enable Authorization Traps. A check mark displays in the
box when transmission is enabled, as shown in Figure 2–27.
Figure 2–27: Configure SNMP dialog box—Enable Authorization Traps
3. Click Activate to save the information and close the dialog box.
Configure and Enable E-mail Notification
Perform this procedure to configure and enable e-mail addresses and simple mail
transfer protocol (SMTP) server addresses to receive e-mail notification of switch (and
other managed product) events. The addresses must be configured at the HAFM
application, then enabled. See “Task 13: Test Remote Notification (Optional)” on
page 2–50 for instructions on testing this notification feature.
To configure and enable e-mail and SMTP server addresses:
1. At the Product View page, choose Maintenance > Configure E-Mail. The
Configure E-Mail dialog box displays, as shown in Figure 2–28.