HP (Hewlett-Packard) 958-000290-000 Network Router User Manual


 
edge switch 2/32 installation guide 2-51
Installing and Configuring the Edge Switch 2/32
Task 14: Back Up HAFM Configuration Data
It is important to back up the HAFM configuration data. This data is used to restore
the HAFM server operating environment in case of hard drive failure.
Refer to the hp StorageWorks HAFM server installation guide for instructions on
backing up the HAFM configuration data.
Once the HAFM configuration data is backed up, go to “Task 16: Cable Fibre Channel
Ports” on page 2–69.
Task 15: Configure the Switch from the Embedded Web Server
(Optional)
If an HAFM server is not available, use the Embedded Web Server (EWS) interface to
configure the Edge Switch 2/32. Selectively perform the following configuration tasks
according to the customer’s installation requirements:
Configure the switch ports.
Configure the switch identification, date and time, operating parameters, and
network addresses.
Configure SNMP trap message recipients.
Configure user passwords.
NOTE: This section covers the initial set up of the edge switch 2/32. For additional information
regarding setting up zoning, zone sets, and SAN management in general, see the online EWS
help.
A PC platform with LAN access and standard web browser running Netscape
Navigator 4.6 or higher or Microsoft Internet Explorer 4.0 or higher is required. To
open the Embedded Web Server interface:
1. Ensure the browser-capable PC and the Ethernet LAN segment (with the switch
attached) are connected.
2. At the PC, launch the browser application (Netscape Navigator
or Internet
Explorer).