Filter
Top Products
If Necessary, Remove the Termination Resistors
If the SCSI Adapter is installed in the middle of a SCSI bus, that is, not at the end as
shown in figure 1 on page 12, the termination resistors on the SCSI Adapter should be
removed. (This would only occur in an HA solution with greater than two CPUs, or if a
V cable is used.)
See figure 3 for the locations of the termination resistors (remember,
the component locations on the two adapters are identical except for the front
faceplate).
Terminatiin resistors
(Part number 1810-1418)
1234
-1
RRAR
II klldMLl
rl
l-l
OPEN
OPEN r
Figure 3. Termination resistor locations
Installation Procedures
19