Filter
Top Products
Connect Cable and Peripheral Devices
With the adapter installed in the computer, you can now connect the adapter cable and
the peripheral devices.
SCSI Cable Connection
Attach the SCSI cable to the adapter as follows:
1.
Inspect the connector pins to be sure they are straight.
2.
Carefully plug the cable connector into the SCSI adapter receptacle on the
computer system. See figure 10. Note that figure 10 shows the cable being
attached to an HP 9000 Series I&xx computer; the procedure for the HP
9000 Series l%xx computer is very similar.
CAUTION
Do not bend any of the cable connector pins.
Insert connectors by pushing straight in
and remove them by pulling straight out.
Do not rock connector top to bottom or side to side.
3.
Secure the connector with the attached thumbscrews.
4.
Secure the other end of the cable to a SCSI device.
Installation Procedures 29