Filter
Top Products
Install the HP A2969A SCSI Adapter in an HP 9000 Series Kxxx
To instaIl the HP A2969A SCSI adapter in an HP 9000 Series I&xx computer, perform
the following steps:
1.
2.
3.
4.
5.
Shut down the operating system and turn power off to the computer.
(See
page 15.)
Wear a grounding wrist strap that is connected to the core I/O or expansion
I/O bulkhead.
Remove the core I/O or expansion VO from the computer.
Refer to the
computer system manual for the necessary steps to remove the core I/O or
expansion I/O.
Grasp the SCSI adapter by its edges or faceplate.
Do not touch electronic
components or electrical traces. Recheck the DIP switches on the SCSI
adapter for the correct setting.
If the SCSI adapter is to be installed in the core I/O, use the slot labeled
‘OPTIONAL I/O (J/8)*‘.
If the SCSI adapter is to be installed in the
expansion I/O, select an empty slot on the expansion I/O.
See figure 4 for
slot identifications.
InstallationProedures21