Filter
Top Products
Figure 7. HP-H!3C I/O bus converter
To install the HP A3644A SCSI adapter in an HP 9000 Series T6xx computer, perform
the following steps:
1.
Shut down the operating system and turn power off to the computer.
(See
page 15.)
2.
Wear a grounding wrist strap that is connected to the HP-HSC I/O bus
converter bulkhead.
3.
Remove the HP-I-NC J/O bus converter from the computer.
Refer to the
computer system manual for instructions.
4.
Grasp the SCSI adapter by its edges or faceplate.
Do not touch electronic
components or electrical traces. Recheck the DIP switches on the SCSI
adapter for the correct settings.
Installation Procedures 26