Filter
Top Products
4-30 Service Calibrations
Calibrating the
Service Station
1. From the Front Page, select Calibrations > Service Cali-
brations > Service Station Calibration.
• If you already entered this calibration from the previous
calibration, skip this step and go to the next step.
The control panel prompts you to remove media if any
media is loaded.
2. After unloading any media, press ! (Proceed).
The printer raises the rail, moves the carraige to the middle
of the platen, and prepares the service station for calibration.
3. If the service station is below the level of the platen and
clear of the travel of the carriage, press Proceed to send the
carriage home.
The control panel displays the following screen:
Fig. 4-9. Service station calibration