Filter
Top Products
Menus 3-9
MEDIA WIZARD • Printing Delay — slows throughput (media advance speed)
to allow the media to cool between passes, preventing warp-
ing of rigid media or curling of roll-fed media.
• Gutter Settings — determines the appearance of the top
and side gutters:
• Top Gutters — allows you to turn On or Off the gutter
data at the top edge of the print, which shows the job
name, ink, media, date and time printed, print mode,
lamps setting, printer, embedded software version, Fine
Text and Sharp Edge usage, plus write-in blanks for other
data.
• Side Gutters — sets the side gutter pattern to Narrow,
Medium, or Wide sizes, or turns them Off. Side gutter
patterns help keep the inkjets open by firing ink through
them in a pattern outside the printed image area.
• Margin Settings
• Space Between Prints (roll-fed media only) — sets the
blank space between print jobs, between 0 and 10 inches
(25 cm). A space of 3.25 inches (8.26 mm) or more is
recommended to prevent the grit rollers from marking the
media.
• Right and Left Margin — sets the amount of blank space
for the right and left margins, between 0.25 and 5 inches
(6-127 mm) for roll-fed media, and between 0 and 5
inches (0-127 mm) for rigid cut-sheet media.
When you set the right and left margins to zero (edge-to-
edge printing on cut-sheet media), the printer prompts
you for an Overprint value. This is the distance beyond
the edge of the media to print, to help avoid a blank strip
if the sheet is slightly skewed, not perfectly rectangular,
or other error is present.
Note If you load roll-fed media after printing on cut-sheet
media, the printer automatically resets the right and
left margins to 0.25 inches (6 mm). You can still
change them at any time.
• Leading Margin — defines the margin on the leading
edge of cut-sheet media, between 0 and 15 inches (0-38
cm).