Filter
Top Products
Alea Systems, Inc. Rev.1.13 Pingo-Photo Rep
User manual
11
5.6 Recommended Print Settings
The Pingo Photo printer has a wide variety of settings that can enhance images, colors, and text. As a minimum
quality setting, it is recommended to use any Photo Coat setting as the media type and "Normal" or "Best" for
print quality. Additional changes can be made by selecting the Advanced Tab to adjust the sliders for Saturation,
Brightness and Color Tone.
5.7 Printing on Standard and Business Card Media
The Pingo Photo offers printing on both 120mm standard size CDs and optional 63mm business card CDs. The
CD print surface needs to be ink jet compatible. An optional business card tray insert and clamp adapter is
available with each Pingo photo printer to accommodate business card CD printing.
To print on either media type, the media should be loaded printable side facing up. To print on CD-R media
place the disc in between the 3 metal tabs and send the print job to the printer. For multiple prints, an operator
will need to remove and replace each CD as it is completed. The printer will automatically detect the next disc as
it is placed on the carrier tray.
To install the components to print on business card CD's do the following and see diagrams below:
• Place Clamp Adapter on the Carrier Tray so that the open circle on the adapter fits over the
holding pin that rises up from the rectangler cut out where the clamp adapter will lay.
• Place the Business Card Insert on the Carrier Tray so that the tabs on the insert are lined up to
slide under the square Carrier Tray holes to hold it in place. The smaller holes on the left side
of the insert should click into place over the small, raised circles on the Carrier Tray.
To remove the business card tray, slightly lift up on the tray from the lower left corner with your left hand. While
lifting, slightly pushing to the right with your index finger.
Page
Before the Adapter is
placed on the tray
After the Adapter is
placed on the tray