HP (Hewlett-Packard) HP OmniBook Calculator User Manual


 
63
Check your power management settings using the System Configuration Utility.
If Infrared Monitor is running, the OmniBook doesn’t suspend if automatic
searching is active. In Infrared Monitor, check the status of the search option.
If you have a CD-ROM drive connected, use Device Manager to view the CD-
ROM drive properties. If the auto-detect setting is active, it prevents the
OmniBook from automatically suspending after a period of inactivity while the
CD-ROM drive is present.
If the OmniBook doesn’t turn on
Connect the ac adapter.
Press the blue On/Suspend button to try turning on the unit.
Try adjusting the display.
Reboot the OmniBook.
If you get no response, remove the battery and ac adapter and press the reset
button again—then install the battery or plug in the ac adapter and try resetting
again.
If the OmniBook doesn’t turn on with a fresh battery
If the new battery pack is low, plug in the ac adapter.
If the OmniBook doesn’t suspend immediately
If the OmniBook is performing an operation, it normally waits for the operation to
finish.
If you’re using MS-DOS Prompt in the full screen (not inside a window), it may
take up to 10 to 15 seconds to suspend.
If the OmniBook reboots every time you turn it on
This is normal if you turn it off by pressing the square Off button on the left side
of the computer.
Advanced power management (APM) may be disabled. Check your power
management settings using the System Configuration Utility.
If the battery pack doesn’t charge or stops charging
Check that the battery is fully installed and locked in place.
Turn off the OmniBook, then check that the battery contacts are clean and that
the ac adapter cables are fully plugged in.
Move the OmniBook away from any nearby heat source. Unplug the ac adapter
and allow the battery to cool down. An elevated battery temperature prevents
charging.
If the OmniBook won’t undock
Try turning it on and then undocking. If you’ve set up a password for undocking,
the OmniBook can’t undock while it’s off.
If your OmniBook password doesn’t work