Filter
Top Products
10
HP P4459A 8-Port Fibre Loop Switch Installation & Operation Guide
Installing and Removing GBICs
in the Fibre Loop Switch
Each port that you plan on using on the fibre loop switch must be configured with
an HP-supported GBIC to provide media connectivity. Depending on the GBIC
installed, connectivity options include copper and short-wave multi-mode fiber.
Because each switch port can be configured with any GBIC, you can configure
your switch for a variety of different media options to support your fibre channel
architecture.
The following sections describe:
• Installing a GBIC
• Removing a GBIC
Installing a GBIC
The following procedure describes how to install a GBIC into a switch port.
1. Holding it by its edges, remove the GBIC you are installing from its
antistatic bag.
2. Orient the GBIC in relation to the port you are installing it in so that
the label side (or arrow) is on top.
If your GBIC doesn’t have a label or an arrow to help you orient it, exam-
ine the D connector on it. The wider side of the D-connector should be on
top. Figure 4 shows the orientation for installing a GBIC into a switch port.
Note: GBICs are hot-pluggable. This means that they can be installed and
removed during operation, while the switch is running.
Caution: GBICs are sensitive to static electricity. Static discharge from your
clothing or other fixtures around you can cause damage. To prevent damage to the
GBIC, wear a wrist strap or discharge leash to free yourself of static before
touching it.