Filter
Top Products
Installing the Fibre Loop Switch
15
Figure 6: Mounting in HP Rack System/E and HP Rack System/U Racks
Tools Required
To install the switch in an HP rack, you need a T25 Torx driver and a #1 Phillips-
head screwdriver.
HP Rack Mounting Installation Steps
Installing the fibre loop switch into an HP rack requires the following general
steps:
• Step 1: Preparation
• Step 2: Mark the Rack Column Holes
• Step 3: Place the Barrel Nuts on the Rack Columns
• Also install the “L” and “R” spacers on the front columns of HP Rack
System/E and HP Rack System/U racks only.
Left Front
Rack Column
Left Rear Rack Column
Rails
Switch
Right Front Rack Column
Sleeves
Right Rear Rack Column
"L" Spacer
"R" Spacer