Filter
Top Products
Configuring gated
Troubleshooting gated
Chapter 3 105
Interface Configuration Without strictintfs Option Specified The
following configuration references a non-existent interface, but does not
include the strictintfs option:
traceoptions "tt" general;
interfaces {
interface lan0 lan1 lan3 passive ;
};
rip yes ;
The following is the tracing output that is produced when gated is
started with this configuration:
trace_on: Tracing to "/tt" started
Tracing flags enabled: general
inet_routerid_notify: Router ID: 15.13.119.134
You can also find the results of this same command in the gated_dump
file. In the following segment of a gated_dump file, the interface is listed
as passive in the interface policy statement toward the end of this
example:
Interfaces:
lo0 Index 1 Change: <> State: <Loopback>
Refcount: 2 Up-down transitions: 0
127.0.0.1
Metric: 0 MTU: 4072
Refcount: 4 Preference: 0 Down: 120
Change: <> State: <Up Loopback Multicast>
Subnet Mask: 255.255.255.255
proto: RIP State: <NoIn NoOut>
lan0 Index 2 Address 802.2 8:0:9:1b:da:1f Change: <>
State: <>
Refcount: 2 Up-down transitions: 0
15.13.119.134
Metric: 0 MTU: 1436
Refcount: 6 Preference: 0 Down: 120
Change: <> State: <Up Broadcast Multicast
NoAge>
Broadcast Address: 15.13.119.255
Subnet Number: 15.13.112 Subnet
Mask: 255.255.248