Filter
Top Products
HP 18.1 LCD ” Color Monitor User’s Guide
USING Your Monitor
20 EnglishEnglish
Protected OSD
When this mode is selected the user can adjust the brightness/
contrast and OSD Manager only. To enable or disable protected OSD
mode:
1 Select
PROTECTED OSD
to enter the
PROTECTED OSD
submenu.
2 Select each digit of the six figure password
1
using the
control, pressing each time to confirm your selection.
3
When you have selected the correct password a submenu is
displayed. Select
YES
or
NO
to select or deselect Protected OSD,
then press to exit.
Setting the Amount of Displayed Information
To set the amount of displayed information, change the
screen
resolution
of your computer. The higher the screen resolution, the
more information you can see on the screen. It is recommended that
you use a resolution of 1280 X 1024.
It is recommended that you use a refresh rate of 60 Hz. The image
refresh rate is the number of times per second that the image is
redrawn.
To find out which resolutions and refresh rates are supported by
your monitor, see “Supported Video Modes” on page 21. To change
the screen resolution, please refer to the manual that came with your
computer or your operating system.
Your monitor has a Plug and Play capability (VESA DDC1, DDC2B,
DDC2Bi standard) that enables it to identify itself to suitably
equipped HP computers.
NOTE LCD technology does not cause any flicker at low refresh rates.
1. The default password is 040990