Filter
Top Products
Network Setup menu
In the following table, items that have an asterisk (*) indicate the factory default setting.
Menu item Sub-menu item Sub-menu item Description
Wireless Menu
NOTE: You can also
access this menu by
touching the Wireless
button on the control
panel.
Wireless Direct Settings Wireless Direct On/Off Enables or disables the Direct Wi-Fi wireless access
feature.
Wireless Direct Name Set the product's Direct Wifi name, so you can access it
from other wireless devices that support the Wi-Fi Direct
protocol.
Wireless Direct Mode Set the product's Direct Wifi mode.
●
Select the Print Only option (the default setting) to
allow wireless access to only the product print
functions from a mobile device.
●
Select the Open Network option to allow wireless
access to all product functions and settings from a
mobile device.
Wireless Setup Wizard Guides you through the steps to set up the product on a
wireless network
Wi-Fi Protected Setup If your wireless router supports this feature, use this
method to set up the product on a wireless network. This
is the simplest method.
Run Network Test Tests the wireless network and prints a report with the
results.
Turn Wireless On/Off Enables or disables the wireless network feature.
TCP/IP Config Automatic*
Manual
Automatic: The product automatically configures all the
TCP/IP settings via DHCP, BootP or AutoIP.
Manual: You can manually configure the IP address,
subnet mask, and default gateway. The control panel
prompts you to specify values for each address section.
As each address is completed, the product prompts for
address confirmation before moving to the next one. After
all three addresses are set, the network reinitializes.
Auto Crossover On*
Off
Enables or disables the use of a standard 10/100 network
cable when the product is directly connected to a
computer.
Network Services IPv4
IPv6
Enable or disable the IPv4 and IPv6 protocols. By default,
each protocol is enabled.
Link Speed Automatic*
10T Full
10T Half
100TX Full
100TX Half
Sets the link speed manually if needed.
After setting the link speed, the product automatically
restarts.
28 Chapter 2 Control panel menus ENWW