Filter
Top Products
48 HP ProLiant ML310 Generation 3 Server User Guide
USB tape drive
CAUTION: To prevent improper cooling and thermal damage, do
not operate the server unless all bays are populated with either a
component or a blank.
1. Power down the server ("Powering down the server" on page 21).
2. Remove the bezel ("Unlocking the bezel" on page 22
).
3. Remove the access panel ("Removing the access panel" on page 22).
4. Remove the applicable media bay blank.
5. Install the tape drive.
6. Secure the USB tape drive cable to the USB tape drive cable connector on
the system board ("System board components" on page 11
).
7. Knock out the applicable bezel blanks.
8. Replace the access panel ("Removing the access panel" on page 22
).
9. Install the bezel ("Unlocking the bezel" on page 22
).
10. Power up the server ("Powering up the server" on page 21
).
Full-height tape drive
1. Power down the server ("Powering down the server" on page 21).