Filter
Top Products
50 HP ProLiant ML310 Generation 3 Server User Guide
7. Install the retaining screw.
IMPORTANT: HP recommends installing the tape drive on a
separate SCSI cable to avoid a decrease in performance on other SCSI
devices.
8. Connect the data and power cables to the back of the tape drive.
9. Connect the data cable into a SCSI controller channel ("System board
components" on page 11
).
10. Remove the applicable bezel blanks from the bezel ("Front panel
components" on page 7
).
11. Install the bezel ("Unlocking the bezel" on page 22
).
12. Replace the access panel ("Removing the access panel" on page 22
).
Diskette drives
A diskette drive can be installed in the server in the following ways:
• Install a diskette drive in the chassis ("Installing a legacy diskette drive" on
page 51
)
• Install a diskette drive using a USB cable (when using operating systems that
support USB) ("Installing a USB diskette drive" on page 52
)