Filter
Top Products
Removal and replacement procedures 14
Removing the server from the rack
To remove the server from an HP, telco, or third-party rack:
1. Power down the server ("Powering down the server" on page 13).
2. Loosen the front panel thumbscrews that secure the server faceplate to the front of the rack.
3. Disconnect the cabling and remove the server from the rack. Reverse the server installation steps in
the documentation that ships with the rack-mounting option.
4. Place the server on a sturdy, level surface.
Access panel
CAUTION: Due to the high capacitance in the power supply, always wait 30 seconds after disconnecting
the power cord before removing the access panel.
To remove the component:
1. Power down the server ("Powering down the server" on page 13).
2. Do one of the following:
a. Remove the server from the rack, if applicable ("Removing the server from the rack" on page
14).
b. Remove the tower front bezel, if applicable ("Front bezel (tower model)" on page 15).
3. Loosen the two thumbscrews on the front panel of the server near the access panel.
4. Slide the access panel back about 1.5 cm (0.5 in).
5. Lift and remove the access panel.
NOTE: Turn the access panel over to locate the hood labels. These labels provide information on installing
various options, flexible memory configurations, LED status indicators, and switch settings.
To replace the component, reverse the removal procedure.
Tower feet
Remove the feet.