Filter
Top Products
Removal and replacement procedures 31
NOTE: PPM 1 is embedded in the system board.
NOTE: The appearance of compatible PPMs may vary.
To replace the component, reverse the removal procedure.
DIMM
1. Power down the server ("Powering down the server" on page 13).
2. Do one of the following:
• Unlock and remove the bezel ("Front bezel (tower model)" on page 15).
• Extend the server from the rack ("Extending the server from the rack" on page 13).
3. Remove the access panel ("Access panel" on page 14).
4. Open the DIMM slot latches.
5. Remove the DIMM.
To replace the component, reverse the removal procedure.