Filter
Top Products
Removal and replacement procedures 18
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
SCSI hard drive blanks
To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
NOTE: Depending on model purchased, the server may look slightly different than shown.
To replace the component, reverse the removal procedure.
Hot-plug SCSI hard drives
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
To remove the component:
1. Open the front bezel ("Front bezel (tower model)" on page 15).
2. Determine the status of the hard drive from the hot-plug hard drive LEDs ("Hot-plug SCSI hard drive
LEDs" on page 49).
3. Back up all server data on the hard drive.