Filter
Top Products
Removal and replacement procedures 24
5.
Push up on the release lever and push the drive partially out through the front of the server.
6. Remove the media device.
To replace the component, reverse the removal procedure.
Tape drive
To remove the component:
1. Power down the server ("Powering down the server" on page 13).
2. Do one of the following:
• Unlock and remove the bezel ("Front bezel (tower model)" on page 15).
• Extend the server from the rack ("Extending the server from the rack" on page 13).
3. Remove the access panel ("Access panel" on page 14).
4. Disconnect the data and power cables from the rear of the tape drive.
5. Push up on the release lever and push the drive partially out through the front of the server.
6. Remove the tape drive.