Filter
Top Products
If you already have an IDE-SCSI board installed in the printer,
you do not need to purchase another board on which to install the
Kanji hard disk.
However, you do have to remove the IDE-SCSI board from the
printer before you can install the hard disk. If you have an IDE
hard disk installed on the board, you must also remove that hard
disk. Use the instructions in the previous section, “Storage
Options.”
Due to the size of the Kanji two-byte font sets, you must reallocate the
printer’s memory for seven memory clients. The printer can’t access
the Kanji fonts until its memory is reconfigured. See the
QMS Crown
Kanji Option Installation Instructions
, included in the Kanji Option Kit,
for complete information. However, the following table provides an
overview of the memory reallocation.
» Note:
To configure the memory clients as shown in the following
table, you’ll need either to take memory away from other memory
clients not listed in the table or to add additional memory.
See the
QMS Crown Kanji Option Installation Instructions
, included in
the Kanji Option Kit, for complete information on accessing the Kanji
fonts from a Macintosh, from DOS, and from Windows.
Memory Client Minimum Kanji Setting
K Mem for Spool 112
K Mem for PSHeap 3584
K Mem for PS Fonts 1000
K Mem Emulation 768
K Mem Emul Tmp 256
K Mem Display 512
K Mem Disk Cache 256