Filter
Top Products
Sets the default font index when Select by Index is chosen in the
Administration/Emulations/PCL 5/Default Font menu. If a font by the
same index number exists, it is selected as the default font. This font
must be a cartridge or downloaded soft font.
Controls the default storage location of PCL objects (fonts, macros,
and patterns).
Menu Administration/Emulations/PCL 5/Default Font Idx
Choices 00000-32767
Default Depends on cartridge or downloaded font(s)
Menu Administration/Emulations/PCL 5/Downld Location
Choices Disk—All downloaded PCL objects are stored on the default
disk, if present. These objects remain on the disk even if
the printer power is turned off.
Memory—All downloaded PCL objects are stored in temporary
storage in RAM.
Default Disk
Notes DOC commands specifying resources override this option on a
per-job basis.
If this option is set to Disk and no hard disk is installed,
memory is used as the default storage location.
If the printer has both a hard disk and a large amount of
memory, setting this option to Memory enhances printer
performance.
Before you download any objects, ensure that the printer has
enough memory, or they may not be available for use. If it
doesn’t, you can install SIMMs (see chapter 6, “Printer
Options”) to increase printer memory, or you can install a hard
disk (see chapter 6, “Printer Options”) and enable disk
swapping (Administration/Memory/Enable Disk Swap menu–
see the “Memory” section, later in this chapter).