Configuring VLANs Using SAM
Configuring VLANs Using SAM
Chapter 338
Configuring VLANs Using SAM
You can use SAM to configure VLANs by completing the following steps:
1. Log in as root.
2. Check the HP-UX version by typing: uname -a. The version should
be HP-UX 11i (11.11)
3. At the HP-UX prompt, type: sam
4. At the SAM main window, double click:
Networking and Communications
5. There are then 2 ways to access VLAN configuration. Either choose
the icon Virtual LAN, or choose Network Interface Cards and
then show the VLANs by using the List Pulldown.
SAM displays a list of VLAN-aware physical interfaces and all
VLANs created on them (Figure 3-1).
Figure 3-1 List Pulldown with Virtual LANs Displayed