Filter
Top Products
Using lanadmin -V to Administer VLANs
Using the lanadmin -V Command for Administering VLANs
Chapter 5 49
CONF_TOS or CONF_PRI)
[pri_override <level>(CONF_PRI,IP_HEADER or
CONF_TOS)] <vppa>
-V scan
-V info <vppa>
-V basevppa
-V help
Using lanadmin to Create a VLAN
Assume that the system has the following configuration as shown by the
lanscan command output.
lanscan
Hardware Station Crd Hdw Net-Interface NM MAC HP-DLPI DLPI
Path Address In# State NamePPA ID Type Support Mjr#
1/2/3 0x001083FF9951 0 UP lan0 snap0 1 ETHER Yes 119
1/2/4 0x006023456789 1 DOWN lan1 snap1 2 ETHER Yes 119
To configure a VPPA with VLAN ID 454 and a priority of 6 on “lan0”,
execute the following command.
lanadmin -V create vlanid 454 pri 6 0
Successfully configured
lan5000: vlanid 454 name UNNAMED pri 6 tos 0 tos_override IP_HEADER pri_override
CONF_PRI ppa 0
This command created a VLAN “lan5000” on top of the physical interface
lan0. The PPA associated with this VLAN, 5000, is referred to as a
VPPA, short for Virtual PPA. Note: the parameters that were not
specified in the command have been assigned default values.
Displaying a VLAN and its Properties
You can use the default lanscan command to view all the interfaces as
follows.
lanscan
VLAN0 0x001083FF9951 5000 UP lan5000snap5000 14 ETHER Yes 119
1/2/4 0x006023456789 1 DOWN lan1 snap1 2 ETHER Yes 119