Troubleshooting
Flowchart 1: Link Level Tests
Appendix A 63
Flowchart 1b Procedures
• Execute lanscan command and verify your interface is displayed by
the system.
— If it is displayed, run lanscan -v to ensure the VLAN ID is
correct. If so, return to the network Test. If not, modify the
VLAN to the correct one by running the command
lanadmin -V modify.
— If the interface is not displayed, run lanadmin -V create to
create the VLAN.
• If the problem is fixed, Stop. Else, check for any error messages.
— If there are error messages correct them according to the error
message.
— If there are no error messages, return to the network Test.