Filter
Top Products
You should assign an unused SCSI address to the second SCSI hard disk drive (for example,
SCSI address 1).
The SCSI address is usually configured with jumpers on the SCSI hard disk drive. Refer to the
installation guide supplied with the drive for information on selecting a SCSI address.
Some SCSI disk drives may have termination resistors that must be removed or disabled
before installation in your computer. Refer to the drive’s installation guide for more details and
to see if there is a special installation procedure to follow.
Installing a Hard Disk Drive in an Internal Shelf
NOTE Hard disk drives ordered from HP are supplied with a
mounting tray. If you order your drive from another
supplier, you may need to order a mounting tray from
HP. You should order product number D2037A (3.5-
inch hard disk mounting tray).
1 Disconnect the computer’s power cord and any telecommunications cable.
2 Remove the computer’s cover (see "Removing and Replacing the Cover" earlier in this
chapter).
3 Slide the power supply out to improve access to the drive (see "Moving the Power Supply"
earlier in this chapter).
4 Install the drive in the first or second internal shelf.
If you install the drive in
the first (uppermost) shelf:
Align the drive (upside
down) with the hinges on
the shelf, then insert it into
the hinges
If you install the drive in
the second shelf:
Align the drive with the
slots in the shelf, then
insert it carefully, as
shown here
5 If the drive is being installed in the first shelf, rotate the drive into position.