Filter
Top Products
- - - - - - - - - - Prior Console Output - - - - - - - - - -
Shell>
2. Enter fs0:
Shell> fs0:
3. Enter hpux:
fs0\> hpux
The guest boots from fs0.
If you used a DVD to install the guest operating system, remove the virtual DVD, as follows:
1. Determine the bus, device, and target ID by entering the following command:
# hpvmstatus -P compass1
2. Delete the virtual DVD by entering the following command (substituting the correct PCI bus, slot,
and target number for 0,0,0):
# hpvmmodify -P compass1 -d dvd:scsi:0,0,0
3. If necessary, restart the guest to remove the DVD from the guest configuration.
4.2 Installing HP-UX Guest Management Software
After you install the HP-UX operating system on the virtual machine, install the Integrity VM guest
management software. The guest management software includes:
• Operating system patches to optimize virtual machine operation
• Integrity VM management tools, including hpvmcollect and hpvminfo
• The VM Provider, which allows you to use the VM Manager to manage the guest.
The guestmanagement softwarerepository is installedon the VM Hostsystem automatically. Thefollowing
directory contains the HP-UX guest management software:/opt/hpvm/guest-images/hpux/
The HP-UXguest managementsoftware isincluded inthis directory.A READMEfile containsinstructions
for installing the guest management software. Install the guest management software on every HP-UX
guest.
4.3 Troubleshooting HP-UX Guest Creation
The following section describes a problem that might occur during HP-UX guest installation.
4.3.1 The guest hangs in the EFI shell
The guest hangs in the EFI when you are starting the guest and you get the following message:
Shell> \efi\hpux\hpux
'\efi\hpux\hpux' not found
Exit status code: Invalid Parameter
The EFI boot parameters were probably not set up correctly during guest operating system installation.
Choose the correct EFI partition from which to boot. For example:
Shell> fs3:
fs3:\> hpux
44 Creating HP-UX Guests